Chiness English
Location:Tech Support

Diesel generator set engine longevity six tips

DATE:2019/6/24 14:10:31 HITS:226

We all know that the engine is an important component of the diesel generator set sector, its longevity is likely to determine the length of life of the generator set equipment, then what are the measures in our day-to-day operations can extend the life of the engine? Look at the the induced stand for you a list of six tips.

   The mill that run-in. This is the basis to prolong engine life, new engine or engine overhaul, must be the point of order after running to get ready for normal operation.

   Enough oil enough water enough air enough. If the oil supply shortage or interruption, will lead to poor engine lubrication, body badly worn even bush-burning phenomenon; cooling water will make the machine temperature is too high, power down, increased wear and shorten life; air supply is not timely or interrupt phenomenon, there will be difficulty in starting, poor combustion, power down, the engine can not operate normally.

   Net that net oil, net water, gas, net, and the body net. Diesel, gasoline is not pure, and make precision with body wear, with the gap increasing, causing the oil spill, drip, lower oil pressure, the gap is larger, and even cause the oil duct blockage, axle, bush-burning and other serious fault ; air contains a lot of dust, will accelerate the cylinder, piston and piston ring wear; cooling water is not pure, make the cooling system scale blockage hinder engine cooling, lubrication conditions deteriorated badly worn body; body The appearance is not the net, make the surface from corrosion and shorten life.

   Tune the diesel engine or gasoline engine valve clearance, valve timing, injection timing, injection pressure and ignition timing should be checked in time and adjust to ensure that the engine is in good condition in order to save fuel and prolong life.

   Check that often check the fastening parts. Diesel and gasoline engines by vibration impact and load uneven impact during use, bolts, nuts loose. The different parts of the adjustment the bolts should check to avoid damage to the body's loose accident.

   That is the correct use of the engine. Before driving axis, tile lubricating parts should be lubricated. After the start should be to re-enter the job when the water temperature is above 40 ℃. No prolonged overload or low-speed operations. Downtime should be removed before the load to reduce the speed. After the winter parking until the temperature dropped to 50 ° C, the discharge The net cooling water (Note antifreeze engine except). Usually to do engine maintenance work, the machine always keep running in good condition. To ground observation, ground check, find fault, and remove.

   Six tips listed above can help effective maintenance of the engine, which is equivalent to the protection of the "heart" of the diesel generator set is not only guaranteed operational efficiency, service life has been extended.

  • 13509009815
  • kitty@etonepower.com
  • 506192649
  • No. 1 Changqing South Road, Changan Town, Dongguan, Guangdong

工作时间

早9:00 - 晚18:00

周六日休息

13509009815